+7 (351) 727-27-72
+

GP 734

Glide path radio beacon GP 734

Glide path radio beacon GP 734

Is used to form a signal about aircraft location toward runway centerline in vertical plane

Key peculiarities

  • conformity with FAR and ICAO requirements
  • small amount of devices
  • reduced power consumption of prime equipment
  • forms part of «Complex 734»with single unified system of control and management
  • unification with «Complex734» products

General characteristics

  • conformity with ICAO I, II, III category standards ILS
  • 100% backup of prime equipment
  • possibility to set and change parameters from remote control and monitoring system (RCMS)
  • distance monitoring and control
  • the beacon maintenance mode is uninterrupted, 24-hour, does not require constant staff assistance
  • power supply from monophase network voltage alternating current 220 V, with 50 Hz frequency
  • power, consumed by prime equipment is not above 200 VA

Operating conditions

For devices set in heated space and installations (inside operating room or ATC tower):
the ambient temperature from -10° C to +55° C
relative air humidity at +25° C up to 80%
atmosphere sub pressure below 700 hPa (525 millimeter of mercury column)
efficiency no less than 95%
For devices set in the outdoor air or not heated space:
the ambient temperature from -50° C to +70° C
relative air humidity at +25° C below 98%
atmospheric condensed precipitation hoarfrost, dew
atmospheric precipitation rain, snow
air-flow rate for antenna-feeder devices, km/h below 200
atmosphere sub pressure below 700 hPa (525 millimeter of mercury column)
efficiency no less than 95%

Tech specifications

frequency range, MHz 328.0 - 336.0
glidepath angle, degrees from 2 to 4
in horizontal plane, degrees runway centerline ±8
in vertical plane, degrees from glidepath angle from 0,3 (0,45) to 1,75
area of coverage, km above 18,5

Options

  • structure variants: two-channel dual-frequency or one-channel single-frequency
  • antenna systems: array «0», array «В» or array «М»
  • installation of section DME 734 to GP 734 case
  • device Analyzer ILS/VOR to GP 734 parameters control in the beacon coverage area
  • installation in already existent technical areas and containers
  • security and fire alarms
  • video monitoring
  • distance monitoring and control: wire line, fiber-optic link or radio channel

Catalogs and detailed specifications are available on request only